Blank and vented panels
These panels are mounted to 19" vertical extrusions. The blank panels are used to blank off empty positions in a rack. Through panels serve for cables routing from the front part of a rack to the rear part.
Blank panels - DP-ZA-xU / DP-ZA-xF- Used to cover empty positions in rack to minimize by-pass airflow and enhance aesthetic appearance.
- For blanking of empty positions in a rack and for significant improvement of air flow
- Manufactured in 1U, 2U, 3U and 5U sizes
- Color powder coated RAL (standard RAL 9005)
- Blank panels with tool-less design DP-ZA-xF
19" Vented panels - DP-01-VENT
- Enables front to rear cable passage through empty positions in rack
- Height 1U
- Width 19"
- Color powder coated RAL (standard RAL 9005)
- Enables front to rear cable passage through empty positions in rack whilst helping to minimize by-pass airflow.
- Types:
a) with brush
b) with brush and cable management - Vented panel with brush and cable management has cable management bar on back and two cable brackets 40x50mm on sides
- Height 1U
- Color powder coated RAL (standard RAL 9005)
| Where to
buy These accessories can be purchased through our distribution network - you can find the nearest distributor via the contact locator that is a part of this page. More information needed? |
